OPS One key Restoration of the mainboard and Ctrl +F3 backup Procedure SOP

Jan 22, 2025

Leave a message

OPS Restore the mainboard with one key and Ctrl +F3 backup SOP

Install Chinese cabbage software (see attachment installation package download link) and make Chinese cabbage startup USB disk:

info-554-379

boot fast start select Chinese cabbage start U disk

Select Win8 PE after entering the USB flash drive, as shown in the figure:

info-554-355

After entering PE, open the DISKGENIUS software, as shown in Figure 2:

info-554-486

Use the DISKGENIUS software to delete all disk partitions and click "Save changes", as shown in Figure 3:

info-478-331

Use the DISKGENIUS software to create a new partition 1 format FAT32 with a capacity of less than 32G, as shown in Figure 4:

info-554-298

Use the DISKGENIUS software to create a new partition 2 format NTFS, with any capacity, as shown in Figure 5:

info-554-293

After setting partitions 1 and 2, pay special attention to click "Save changes", as shown in Figure 6:

info-554-280

Click "Save changes" and format partitions 1 and 2, as shown in Figure 7:

info-554-288

After the partition is successful, the final display effect is shown in Figure :8. Then close the DISKGENIUS software:

info-554-281

Restart Win8 PE, and enter win8 PE again, click "Computer" to check the partition status, as shown in Figure 9(you can click partition properties to check whether the partition format is correct) :

info-554-285

Click "Computer" and modify the drive name of partition 1, as shown in Figure 10:

info-554-296

Copy the backup and restoration software and batch processing to partition 1, as shown in Figure 11:

info-554-304

restart the cabbage Win8 PE, as shown in Figure 12, the normal installation of win7,32bit 0s(CD or U disk installation can be) :

info-554-297

Install the system to the disk partition without any operation and click "Next" directly until the OS is successfully installed, as shown in Figure 13

info-554-305

Restart the OS by pressing the hot key Ctrl+F3 until the automatic backup system interface appears (backup system operation), as shown in Figure 14

info-477-307

After the backup system succeeds, it automatically restarts to enter the OS

Restart the OS and press the GPIO Button on the main board until the automatic system restore interface appears (system restore operation), as shown in Figure 15:

info-554-316

19,After the system is successfully restored, the system automatically restarts to enter the OS

Note :(1) Recommended value for system backup and restoration :Win7 Ultimate 32bit 0s

(2) If an error message is displayed during the backup/restore process, you are advised to perform multiple backup/restore operations. Generally, errors may occur during the restoration process (caused by backup images).

(3)0PS motherboard test this function, BIS0 test point 1:Ctr+F3(backup), Ctr+F4(restore) effective

BIS0 test point 2: press GPI0 Button automatically appear restore system interface is effective, as for backup/restore success BIOS can not control!

Difficulty (1): After the partition is completed and after the installation of 0S, the disk manager always does not allow the file size of 100M, so the partition is reserved;

Send Inquiry