1. The environmental humidity is not suitable
Industrial computer is mainly composed of integrated circuits of many electronic components, and its insulation performance has a great relationship with environmental humidity. Excessive humidity can easily cause short circuit and burnout of the circuit board. If the humidity is too low, it is easy to generate static electricity, and some electronic components will be damaged. This requires a good instrument grounding on the industrial control computer. Therefore, high and low humidity will bring potential threats to industrial control computers.
2. The ground feel must be stable
In an automatic control system, long-term high-speed operation of the disk will easily lead to a decline in the read and write capacity of the disk, slow head positioning, and even damage to the disk due to vibration. In engineering design, the industrial control computer should be as far away as possible from the work site with large earthquake sources. If the work location cannot be changed, sponges and cushions can be placed under industrial control cabinets and boxes to reduce the damage caused by vibration.
3. The temperature is inappropriate
If the chassis temperature reaches 30 degrees Celsius, the internal hard drive temperature will reach 40 degrees Celsius or higher. You can simply control your industrial computer to lower the ambient temperature. (1) Replace the high-power CPU and hard disk fan (the hard disk fan should be fixed and should not be installed on the hard disk firmware frame to prevent the hard disk from vibrating due to the rotation of the fan) to speed up heat dissipation; (2) in the chassis Install a fan inside to exhaust the air outside the chassis, thereby increasing air convection; (3) Install a small axial flow fan on the cabinet where the industrial computer is placed; 4. Equip the control room with air conditioners to reduce the space temperature.
Fourth, the power supply voltage fluctuates greatly, which is prone to power failure
With the rapid development of industry and life, the demand for electricity is also increasing. In many areas, there are insufficient power supply, unstable voltage and easy power outages. Unstable voltage and sudden power failure cause frequent system restarts, and system files are easily lost and cannot start normally. Magnetic heads that perform read and write operations sometimes cause disk failures in industrial personal computers due to head return failures. Therefore, the stability of the power supply in the working environment of the industrial control computer is related to the normal operation of the industrial control computer. Regulated power supply and uninterruptible power supply can be used for protection. The specific equipment selection depends on the load power and the operating time to be maintained.
5. There are many inhalable particles in the air
Most raw materials in many factories need to be processed with powder. In addition, due to the large flow of external air and dust, a large amount of viscous dust can easily accumulate in the industrial control computer, resulting in excessive local temperature and hardware damage in the industrial control computer. This situation often occurs around cooling fans, such as central processing units, power supplies, hard drives, and graphics cards. For places with light dust accumulation, regular soot blowing can be used if normal production permits. For places with heavy dust accumulation, dust filters can be installed in the ventilation part of the industrial control cabinet and cleaned regularly.
